Defective Safety Belts And Lifelines May Have Contributed To A Construction Accident.
At California City construction sites, falls are the leading cause of
death and the most common construction-related injury.California Law
mandates the use of lifelines and safety belts for employees working at heights
as a means of enhancing worker safety.
Accidents that
construction workers in California have encountered.
Among the most common causes of construction site injuries are falls,
electrocution, and equipment failure due to negligence.
Below, we'll go over each of these topics in more detail, with links
to additional resources.
●
Falling objects can strike a worker, or a worker
can fall to their death from a great height. Accidents involving falling objects
are fairly self-explanatory and frequently the result of human error.
Scaffolding failures, issues with ladders, broken floors, or the failure of
lifts are common causes of worker falls.
●
Crane accidents and debris, demolition accidents,
and faulty lifts used by window washers on high rises all fall under the
category of construction equipment failure.
●
If proper safety precautions have been followed,
electrocution accidents are usually clear-cut cases of negligence. Injuries
caused by electrocution can be caused by faulty equipment that should have been
replaced, cut corners, or site managers not enforcing the correct procedures.
Regulations for
lifelines, safety belts and restraint systems are contained in Section 23
Using equipment that is not approved. There must be an approval
process in place for safety belts, harnesses, and other special devices that
are attached to hanging lifelines.
●
Attachments that don't work. All safety belts and
harnesses must be attached to a tail line or hanging lifeline that is securely
anchored in the ground. A worker cannot fall more than five feet from these
attachments.
●
Failed training. Safety belts and harnesses must
be properly worn, used, and attached by all employees before they can be put to
use. Employees who wear belts or harnesses while working should also be checked
for compliance with safety regulations by their employers.
●
Tail lines that are weak or trailing. At least
4,000 pounds breaking strength is required for tail lines, which must be made
of approved materials (such as manila or synthetic fibre). Tail lines should
never be longer than four feet in length, and should be kept to the minimum
length necessary to perform work.
●
Insufficient means of escape. At least 4,000
pounds breaking strength is required for a lifeline to secure to an anchoring
point. Any place where a hanging lifeline comes into contact with a building
edge, protrusion, or object that could cut or weaken the lifeline should be
protected with padding.
●
Using faulty safety equipment. A competent person
must inspect all of the safety belts, harnesses, and lifelines before each use.
The unsafe equipment must be removed from the job site if it shows any signs of
damage (such as mildew, tears, excessive wear, or deterioration).
After a
Construction Accident, the Assistance You'll Need
The California Construction injury lawyers at DYS Law Group can assist you if you were injured in a fall while working on a construction site. For more information on your legal options following a construction site accident, request our Form you can call us at 213-855-4749
Comments
Post a Comment